Your wireless range extender, Light status description, Image of rear side explaining ports and buttons – Philips SNR6500 User Manual
Page 6: Image of bottom side
Your Wireless Range Extender
EN
7
Wireless Base Station 11g True Turbo
Wireless Modem/PC
Power
Light
Status
Description
Wireless
On
Wireless Link is up
Blinking
Send / Receive data
Off
Wireless signal is disabled
Modem/PC
On
Connected to a Ethernet Broadband Modem
Off
Not connected
Power
On
Power on, normal operation
Off
Power off or failure
Image of rear side explaining ports and buttons
‘5V
1A’ port
Connect the included power adapter to this inlet.
‘To Modem/PC’ port
Wide Area Network port.
Connect this to your broadband modem
‘Switch’ button
Switch this button to change the mode.
- RP: Repeater mode (Default),
- EC: Ethernet Client mode,
- AP: Acces Point
Image of bottom side
‘Reset’ button
Press this button for at least 5 seconds to reset the
wireless base station to its factory default settings.
WARNING: THIS WILL DELETE YOUR
CONFIGURATION!
To reset the Wireless Range Extender (WRE)
without losing the configuration settings, see ‘Reset’.
TO Modem/PC
5V=1A
AP EC RP