Pella Clad Hinged patio Door With Adjustable HInges 80JJ0103 User Manual

Page 5

A. Apply side ﬂashing tape. Cut two

pieces of ﬂashing tape 4" longer than
the frame height of the door. Apply one
piece 1/2" onto the frame cladding,

OVER

SHOULD

DOOR

FOLDING

INTEGRATING THE DOOR TO

THE WATER RESISTIVE BARRIER

L. Check door operation. Open and close the door to check for proper operation. Make

sure the door will latch correctly.

Note: If there are any problems with the operation, recheck and
adjust the reveal.

M. Adjust the reveal if needed. The door panels have adjustable hinge

LEAFS

Note: DO NOT adjust the hinge with the top and bottom screws
loose; this could force the hinge to adjust beyond its design capability
which can cause the hinge to bind, damage the hinge and/or pull out
the screws. A 3/4 turn of the center screw provides approximately
1/16" adjustment.

N. On doors with a lock strike in the side,

PILOT

Note: This step does not apply to center latching double doors.

O. Install a #8 x 3" ﬂat head stainless steel screw

&YUFSJPS

Note: The ﬂashing tape must be applied approximately 1/2"
onto the frame cladding at the jambs and head. Pre-folding the
tape at 1/2" before removing the paper backing will make it
easier to apply the tape correctly. If the siding is less than 1/2"
thick, adjust the dimension of the fold so the exterior sealant
line will cover the exterior edge of the tape.