beautypg.com

Poulan 172777 User Manual

Page 15

background image

15

ASSEMBLE STARTER ROPE GUIDE

(USE HARDWARE GROUP “G”)

CENTER MOUNT TYPE
• Install threaded end of rope guide

through hole in top of lower handle
cross bar.

• Loosely assemble 1/4-20 keps lock nut

on threaded portion of rope guide. Do
not tighten.

• Hold control bar against upper han dle

and slowly pull starter rope out and up
over lower handle cross bar and slip into
loop of rope guide.

• Push rope guide down against cross bar

and tighten nut securely.

Throttle con trol
(If equipped)

1/4-20
Locknut

Cable
ties

1/4-20 Machine
screw
or hex bolt
sup plied

Control bar

Lower handle

1/4-20 Keps locknut

Engine starter rope

Rope guide

SIDE MOUNT TYPE
• Put threaded end of rope guide through

hole in side of upper handle above lower
handle crossbar. Se cure with 1/4-20
keps locknut.

• Hold control bar against upper handle

and slowly pull starter rope out until rope
will slip into loop of rope guide.

Upper
handle

Engine
starter
rope

Rope guide

1/4-20
Keps locknut

Lower handle

crossbar

Control bar

SPARK PLUG BOOT (IF EQUIPPED)

(NO HARDWARE REQUIRED)
On some model lawn mowers a spark plug
boot is packed loose in the parts bag. If
your model has one, install it on spark plug
wire and then reconnect plug to spark plug.

ASSEMBLE GRASS CATCHER

(REAR DISCHARGE MODELS ONLY)
(NO HARD WARE REQUIRED)
• Put grass catcher frame into grass bag

with rigid part on bottom.

• Slip vinyl bindings over frame. If bind-

ings are too stiff, hold them in warm
water for a few minutes. Allow bag to
dry before using.

Boot

Spark
plug

Spark

plug wire

Catcher frame

Vinyl binding

Frame

opening