Powermatic WMH TOOL GROUP PWBS14 - Manual (Page 12)

12
3. With the aid of a second person, lift the saw
body out of the shipping container and place
on top of the stand. Be sure front of saw (with
Powermatic logo) faces curved stand front.
WARNING
Saw body is heavy! Use caution when lifting
and stabilize until firmly attached to the
stand! Failure to comply may cause
serious injury!
4. Line up holes in the saw body with holes in
the top of the stand. Fasten saw body to the
stand with four M8 x 40 hex cap screws, eight
M8 washers, four M8 lock washers, and four
M8 hex nuts (Fig. 2)
5. Push motor cord and strain relief plate
through the opening in the side of the stand.
Fasten the strain relief plate to the stand with
two M5 x 12 pan head screws as shown in
Fig. 3.
6. Connect the plugs of the switch cord and
motor cord (Fig. 3). Do not connect
machine to power source during
assembly.
7. Check the alignment of the pulleys by placing
a straight edge against the flat sides of the
motor and wheel pulleys (Fig. 3a). If the
pulleys lie in a straight plane (Fig. 3b) they
are aligned. If they do not lie in a straight
plane, loosen the set screw on one of the
pulleys and shift the pulley in or out until both
pulleys lie in a straight plane. Tighten set
screws.
8. Open the lower door, and place the v-belt
around the motor pulley and the wheel pulley
(see Fig. 3a).