Powermatic WMH TOOL GROUP PWBS14 - Manual (Page 11)

11
RECEIVING
Open shipping container and check for shipping
damage. Report any damage immediately to
your distributor and shipping agent. Read the
instruction manual thoroughly for assembly,
maintenance and safety instructions.
Contents:
Container #1
1 saw body
1 v-belt
1 trunnion support
1 main table
1 extension table
2 table lock knobs
1 table pin
1 work light
1 blade hook
2 fence hooks
2 miter gauge hooks
1 bag of fasteners
1 rip fence & rail assembly
1 blade tension handle
1 instruction manual
1 warranty card
Container #2
1 stand with motor
1 miter gauge
1 pulley cover
1 fence body
INSTALLATION & ASSEMBLY
Tools required
3/8" to 1" combination wrench set and
adjustable wrench
3mm hex wrench
#1 and #2 cross point screwdrivers
NOTE: If further clarification is needed for any
of the following assembly procedures, consult
the exploded views at the back of this manual.
1. Remove loose items from inside of stand.
2. Place cabinet stand upright on a level
surface. If desired, the stand can be further
stabilized by securing it to the floor with lag
screws through the inside corner holes. If
using a mobile base, lock the casters before
assembling or operating the band saw.