Powerware BestLink IPK-0319 - Manual (Page 21)

15 BestLink SNMP/WEB Adapter User’s Guide
:
LTM-1343 B Draft 10/03/2001
C H A P T E R 4
R
EMOTE
C
ONFIGURATION
Use the following procedure to use the adapter’s configuration program
through a web browser.
NOTE Verify that an active 10BaseT cable is connected to the adapter’s network connector.
Add a Routing Condition in the PC
If the IP address of the PC is on the same network with the BestLink Adapter,
you may just run the web browser directly.
If the IP address of the PC is not in the same network with the BestLink
Adapter (only required while configuring the adapter), you can use the Add
Routing command.
1. Turn on the PC and set up the TCP/IP protocol if needed.
2. Enter the following command to add a routing condition:
Route add 192.168.7.18 192.72.173.20
where 192.72.173.20 is an example IP address for the PC and
192.168.7.18 is the default IP address of the adapter.
NOTE Refer to your operating system documentation for additional details on how to add a
routing condition.