Set snmp/web card control group, Set write access managers – Powerware BestLink IPK-0319 User Manual
Page 18
Local Configuration
12
BestLink SNMP/WEB Adapter User’s Guide
:
LTM-1343 B Draft 10/03/2001
Set the IP Address, Gateway Address and MIB System Group
Use this function (option
1
) to set the IP address, the gateway address, or the
management information base (MIB) parameters of the adapter, as listed in
Table 1.
Table 1. IP Address, Gateway Address, and MIB System Group Parameters
No.
Function
Description
Example/Remark
1
IP Address
IP address of the adapter
192.72.173.188
2
Gateway Address
Default IP address of the network gateway
192.72.173.254
3
Network Mask
Subnet mask setting
255.255.255.0
4
sysContact
System contact string for MIB-2 (up to 255 characters)
Powerware
5
sysName
System contact string for MIB-2 (up to 255 characters)
BestLink SNMP/WEB Adapter
6
sysLocation
System contact string for MIB-2 (up to 255 characters)
TEST LAB
7
SNMP/WEB card
version
Firmware version
Information only
8
Ethernet address
MAC address
Information only
Set SNMP/WEB Card Control Group
For those users who intend to use BOOTP/DHCP, telnet, or secure HTTP in
order to configure, control, update, or manage the adapter, certain control
parameters must be enabled or disabled. Use this function to modify those
parameters (option
2
).
NOTE To prevent unauthorized viewing of the web pages presented by the BestLink
SNMP/WEB Adapter, use this function to enable HTTP Security Control.
Set Write Access Managers
For those users who intend to use an SNMP-compatible network management
system (NMS) to manage the BestLink Adapter, the IP address of the
management station must be added in the list on the BestLink Adapter in
order to receive write access rights. Use this function to add or delete the IP
address of the management station (option
3
).