Pioneer VSX-1014TX - Manual (Page 22)

Connecting up 03
22
En
3-D view of 7.1 channel speaker setup
AC outlet
Power supplied through this outlet is turned on and off by
the receiver's power switch. Total electrical power
consumption of connected equipment should not exceed
100 W (0.8 A).
Caution
• Do not connect a TV set , monitor, heater, or similar
appliance to this unit's AC outlet.
• Do not connect appliances with high power
consumption to the AC outlet in order to avoid
overheating and fire risk. This can also cause the
receiver to malfunction.
• Since a subwoofer or power amplifier can exceed the
100W maximum when playing sources at a high
volume, this type of equipment should not be
connected to the AC outlet.
Note
• This unit should be disconnected by removing the
power plug from the wall socket when not in regular
use (ex. when on vacation).
Power cord caution
Handle the power cord by the plug. Do not pull out the
plug by tugging the cord and never touch the power cord
when your hands are wet as this could cause a short
circuit or an electric shock. Do not place the unit, a piece
of furniture, etc., on the power cord, or pinch the cord.
Never make a knot in the cord or tie it with other cords.
The power cords should be routed such that they are not
likely to be stepped on. A damaged power cord can cause
a fire or give you an electrical shock. Check the power
cord once in a while. When you find it damaged, ask your
nearest Pioneer authorized independent service
company for a replacement.
Operating other Pioneer components
Many Pioneer components have SR CONTROL jacks
which can be used to link components together so that
you can use just the remote sensor of one component.
When you use a remote control, the control signal is
passed along the chain to the appropriate component.
Note that if you use this feature, make sure that you also
have at least one set of analog audio or video jacks
connected
to another component for grounding
purposes.
Note
• If you want to control all your components using this
receiver’s remote control, refer to Controlling the rest
of your system on page 50.
• If you have connected a remote control to the
CONTROL IN jack (using a mini-plug cable), you
won't be able to control this unit using the remote
sensor.
B L
R L (Single)
ND SURROUND BACK /
SWITCHED 100W (0 . 8A) MAX
AC 120 V 60Hz
SELECTABLE
SELECTABLE
AC OUTLET
CONTROL
OUT IN
OUT
IN
CONTROL
Receiver
Remote
control
unit
Other Pioneer products
with CONTROL terminals
Connect to CONTROL
terminal of other
Pioneer products
VSX_1014.book.fm 22 ページ ２００４年５月１４日 金曜日 午前９時２４分