Panasonic SJ-MJ88 - Manual (Page 27)

Adjustment mode Display
Laser power adjustment T0E
Off-set automatic adjustment T1E
Magneto-optical disc automatic adjustment T2E
Playback-only disc automatic adjustment T3E
Jitter meajurement (74minutes) T4E
Jitter meajurement (60 minutes) T5E
Destination change T6E
Off-set automatic adjustment value check T7E
Magneto-optical disc automatic adjustment
value check T8E
Playback-only disc automatic adjustment value
check T9E
Error rate measurement (double velocity) TAE
ROM collection TBE
DRAM check TCE
Aging TDE
Tilt measurement TEE
PWB inspection TFE
*In the display of T0E ~ TFE shown above, you must adjust T0E , T1E , T2E and
T3E . You must perform the adjustment by observing the order T0E T1E T2E
T3E .
6.2.2. Laser Power Adjustment
Adjust each laser power: read power for reading (play).
6.2.2.1. Set the Unit to the Adjustment Mode
Cautions
About handling the optical pickup and the magnetic head.
-
The optical pickup is structured precisely; therefore, it is very fragile. Be
careful not to touch it with the edge of the laser power meter. Do not touch
the lens.
-
The sensor of the laser power meter is a very fine part. Be careful not to touch
it to the optical pickup lens.
-
The focus point of the laser reaches to 356°F. Therefore, avoid adjusting
using laser power for a long time because the sensor of the laser power
meter may be burned.
-
Do not set the unit to the laser power adjustment mode with the MD loaded.
Doing so may result in damage to the MD.
27