Paxar Pizza Hut TC941XQR User Manual
Quick reference, Loading labels for hot-hold (peel) labeling
P
P
e
e
e
e
l
l
D
D
o
o
o
o
r
r
P
P
e
e
e
e
l
l
B
B
a
a
r
r
P
P
e
e
e
e
l
l
R
R
o
o
l
l
l
l
e
e
r
r
S
S
u
u
p
p
p
p
l
l
y
y
H
H
o
o
l
l
d
d
e
e
r
r
G
G
u
u
i
i
d
d
e
e
s
s
Quick Reference
Switching Between Print Modes—Peel Mode or Non-peel Mode
1. Press the Pizza Hut
®
button on your keypad/terminal.
2. Press the Cheese button to display “NON-PEEL MODE” or “PEEL MODE” until the
print mode you want is displayed.
3. Press the Pizza Hut
®
button to save your choice.
4. The printer LED will blink red. Press the printer FEED button. The printer LED will
turn green, indicating the printer is ready. Default mode is non-peel.
Loading Labels for Hot-Hold (Peel) Labeling
Follow these instructions to print and peel labels from the backing paper one at a time.
1. Press the cover release levers towards
you to release the cover and then lift it
open.
2. Pull out the peel door located on the
front of the printer to display the peel
roller and the peel bar.
3. Remove a supply holder guide from one
end of the supply holder.
4. Slide a roll of labels onto the supply
holder.
5. Place the supply holder guide back onto
the end of the supply holder.
Push the label core adapters into the
ends of the supply and center
the labels
on the supply holder. The number 4 (on
the supply holder) should be visible on
either side of the supply holder guides.
P
P
e
e
e
e
l
l
D
D
o
o
o
o
r
r
O
O
p
p
e
e
n
n
i
i
n
n
g
g
P
P
e
e
e
e
l
l
R
R
o
o
l
l
l
l
e
e
r
r
L
L
a
a
b
b
e
e
l
l
R
R
o
o
l
l
l
l
M
M
o
o
u
u
n
n
t
t
6. Place the loaded supply holder in the slots
in the label roll mount. Push the plastic
line attached to the end of the supply
holder out of the way.
7. Remove the first two labels from the
backing paper.
8. Feed the labels, printing side up, under the
supply guides and over the platen roller.
9. Feed the backing paper under the peel
roller and through the peel door opening.
TC941XQR Rev. AA 3/04
©2004 Paxar Americas, Inc. All rights reserved.