Pride Mobility INFMANU1773 - Manual (Page 12)

12 Basic Operation Instructions
Remote Plus Controller www.pridemobility.com
Mode Key (Speed Settings)
The mode key controls the speed settings. The Remote Plus speed settings range
from 1 to 5. Typically, the slowest speed setting is 1 and the fastest speed setting
is 5. The settings are indicated by the number of lights that are lit on the speed
setting indicator.
NOTE: The speed settings are preset at the factory. If your authorized
Pride Provider changes the order of these settings, please make note of
these changes. Contact your authorized Pride Provider for more informa-
tion.
NOTE: Profiled joysticks function differently than those without profiles.
If your power chair was programmed with more than one drive profile,
contact your authorized Pride Provider for more information regarding
operation.
Horn Key
The horn key activates a warning horn.
Battery Condition Meter
The battery condition meter is a 10-segment illuminated display located in front of
the joystick. When the lights are on, it indicates that there is power to the Remote
Plus. The lights also indicate battery status, Remote Plus operational status, and
electrical system status.
!
! ! ! ! Red, yellow, and green lights lit: Batteries charged; controller and electrical
system OK.
! ! ! ! ! Red and yellow lights lit: Charge batteries if possible; controller and electrical
system OK.
! ! ! ! ! Red lights only lit or slow flash: Charge batteries as soon as possible;
controller and electrical system OK.
! ! ! ! ! Rapid flash of lights: The Remote Plus has detected a problem in the electrical
system and power chair drive operation is inhibited. Refer to “Fault Codes.”
! ! ! ! ! Ripple up and down of lights: The joystick was not in the neutral position
when the controller was turned on. If you get “ripple up and down of lights,”
turn off the controller and allow the joystick to return to the neutral position,
then turn on the controller.