Philips SDV9201/17 - Manual (Page 4)

Assembly and installation instructions
Before assembling the antenna, take a moment to familiarize yourself with the
antennas’ construction. Notice that the boom of the antenna has a top and bot-
tom. The horizontal elements are mounted to the top side of the boom. The
reflector on the other hand, does not have a specific top or bottom.
1. Extend the folded drive element by carefully folding the “wings” outward so
they are at 90 degrees to the boom. (fig.3)
2. Attach Transformer to bottom studs of drive elements with wing nuts and
washers. (fig.4)
3. Slide the reflector screen onto the boom from the rear until the screw holes
of the screen bracket line up with the holes on the top and bottom of the
boom.Attach the screen to the boom using two (2) 1-1/2” bolts, lockwashers
and wing nuts.
Tip:
To make it easier to fit when sliding the screen onto the boom, squeeze the top
and bottom of the screen towards each other.
4. Insert end caps at end of boom (fig. 5).
5. Attach the antenna to the mast: Assemble U-bolt to cross piece. Attach U-
bolt assembly loosely to antenna, using saddle, lockwashers and nuts. insert
mast through U-bolt.Tighten nuts securely (fig.5) (Mast sold separately).
6. Connect 2 mast sections as shown in figure 6 (included in SDV9201K only)
EN
Assembly and installation
4
fig. 3
fig. 4
fig. 5
fig.6