Programming with ’videoplus, How to programme a recording manually – Philips TYPE VR 175 User Manual
Page 2

&
Programming with ’VIDEOPlus+’
All the information required for a programming is contained encoded in the VIDEOPlus code.
1
Switch on the TV set.
2
Press the
TIMER k
button on the remote control.
3
Please enter the VIDEOPlus -code (up to 9 digits) printed in your TV guide next to the start time
of a TV programme.
If you make a mistake, clear with the
CLEAR (CL)
button.
4
If you want to programme at daily or weekly intervals, press the
SELECT
button until ’D-DAILY’
(daily intervals) or ’W-WEEKLY’ (weekly intervals) appears in the display. The ’daily intervals’
function can only be used for recordings to be made from Mondays to Fridays inclusive.
5
Confirm the entries with the
OK
button . The resultant data appears on the TV screen.
Note: If you use VIDEOPlus for the first time for this TV channel, the ’SELECT PROG’ line
appears when you confirm the VIDEOPlus code. Select and confirm the programme number for
this particular TV programme.
* Switch ’VPS’ or ’PDC’ (V/P) on or off with the
SELECT
button.
* If you wish to set a later end time for a recording, press the
P q
button at step
5
. With
each press on the
P q
button you add 15 minutes to the time.
* If e.g.: ’20:00’ appears in the display, please set the clock.
6
Finally, press the
OK
button. Programming is now complete.
The data has been stored in a TIMER block.
7
Make sure that a cassette without erase protection has been loaded. Switch off with the
STANDBY m
button.
A programmed recording should only function when the video recorder is switched off with the
STANDBY m
button.
Note:
* VIDEOPlus aerial-code numbers: With this set, VIDEOPlus aerial-code numbers will be
allocated automatically.
How to programme a recording manually
1
Switch on the TV set. Press the
TIMER k
button twice.
2
Select a free TIMER block. Press the
TIMER k
button.
DATE PROG START V/P END
01
01
20:00
21:30
------------------------
NEXT
gTIMER CLEAR
gCL
-/+
0-9
D/WgSELECT
OK
3
With the
TIMER k
button you choose between the entries ’DATE’ (date), ’PROG’ (programme
number), ’START’ (start time) and ’END’ (stop time).
You can enter or adjust data. Confirm each entry with the
TIMER k
button.
You can switch ’VPS/PDC’ (’V/P’) on and off at step ’START’ with the
SELECT
button.
You can select between ’D’ (daily intervals) or ’W’ (weekly intervals) at step ’DATE’ with the
SELECT
button.
4
Finally, press the
OK
button. Programming has now been completed.
5
Make sure that a cassette without erase protection has been loaded. Switch off with the
STANDBY m
button.
A programmed recording will only function when the video recorder is switched off with the
STANDBY m
button.
Note: Clear a TIMER-block: At step
1
select the TIMER block you want to clear. Press the
CLEAR (CL)
button. If e.g.: ’20:00’ appears in the display, the clock must be set.