Polk Audio Atrium Sat30 User Manual
Page 4
Cabinet
Rubber
Bumper
Ground
Stake
Security
Plate (Optional)
#10 Pan
Head Screw
1/4" Split Ring
Lock Washer
#6 Pan
Head Screw
Bracket
Clamp
Knob
MOUNTING THE ATRIUM Sat30
GROUND MOUNT
To mount the Sat30 into the ground
with a security plate, you will need
the following hardware:
• Sat30 Loudspeaker
• Ground Stake
• Security Plate
• Rubber Bumper
• 1 #10 Pan Head Screw
(for security plate)
• (1) 1/4" Split Ring Lock Washer
• 2 #6 Pan Head Screws
(for loudspeaker assembly to the stake)
Aiming the Speaker
Max Depth—7 1/4"
Ground Mounting Depth
Exploded View Of Sat30
6
Polk Audio Customer Service 800-377-7655 (Outside USA & Canada: 410-358-3600)
Customer Service Hours of Operation: Monday-Friday, 9
AM
-6
PM EST
7
Instructions:
1. Attach stake to security plate using
the #10 pan head screw and 1/4"
split ring lock washer.
2. Dig a hole to the diameter of the security
plate (6 1/2") and to a depth (max 7 1/4" /
min 2 1/4") that will stabilize and secure
the speaker once the earth has been
tamped down around the plate.
3. Place the stake/security plate
assembly in the hole and cover with
dirt, tamping down the soil with
your foot as you fill in the hole.
4. Attach the Atrium Sat30 to the stake
using the rubber bumper and the #6
pan head screws.
5. Loosen the knob to aim the speaker.
When the speaker is aimed properly,
tighten the knob.
WARNING: Aiming the Sat30 to an angle
greater than 45 degrees to the horizontal
may result in water buildup inside the grille
that could cause damage to the speaker,
especially during cold weather when
freezing may occur.
Ground Mount Without Security Plate
If you choose to mount the Sat30
loudspeaker in the ground without the
security plate, be sure the ground is
compact enough to hold the speaker
and stake securely in the ground. Gently
drive the ground stake into the ground
using a rubber mallet and follow
instructions from step 4.