Pioneer DEH-P55BT - Manual (Page 14)

Listening to the radio
1 1 1 1 2 2 2 2 3 3 3 3
4 4 4 5 5 5 6 6 6
These are the basic steps necessary to operate
the radio. More advanced tuner operation is
explained starting on the next page.
This unit
’s AF (alternative frequencies search)
function can be turned on and off. AF should
be off for normal tuning operation (refer to
page 18).
1 Band indicator
Shows which band the radio is tuned to,
MW/LW or FM.
2 Preset number indicator
Shows which preset has been selected.
3 Frequency indicator
Shows the frequency to which the tuner is
tuned.
4 Battery strength indicator
Shows the battery strength of cellular
phone.
! Battery strength indicator may differ
from the actual battery strength.
5 Signal level indicator
Shows the signal strength of cellular phone.
! Signal level indicator may differ from the
actual signal level.
6 Stereo (5) indicator
Shows when the selected frequency is
being broadcast in stereo.
1 Press SOURCE to select the tuner.
Press SOURCE until you see TUNER dis-
played.
2 Press BAND to select a band.
Press BAND until the desired band is dis-
played, FM1, FM2 for FM or MW/LW.
3 To perform manual tuning, push
MULTI-CONTROL left or right.
The frequencies move up or down step by
step.
4 To perform seek tuning, push and hold
MULTI-CONTROL left or right for about one
second and release.
The tuner will scan the frequencies until a
broadcast strong enough for good reception is
found.
# You can cancel seek tuning by pushing
MULTI-CONTROL left or right.
# If you push and hold MULTI-CONTROL left or
right you can skip stations. Seek tuning starts as
soon as you release
MULTI-CONTROL.
Tuner
En
14
Section
04