Paxar 9430RX - Manual (Page 19)

2-6 Configuring the Printer
ESC Starts the command language.
‘cmdbbw’ Search for black mark backward command.
Enter QB.
The maximum number of lines to move backward
in 0.25mm line increments (in 00 hex – FF hex).
Printer Responses
See the printer’s response to the black mark commands in the following table.
Command Response Description
ESC-'Q'-3F hex-3F hex-#high#-#low# Black mark found. ESC QR39
ESC QB35
ESC-'Q'-30 hex-30 hex-#high#-#low# Black mark not found
#high# The left digit of the hex number representing the
number of lines moved to find the black mark in
30 hex – 3F hex.
#low# The right digit of the hex number representing the
number of lines moved to find the black mark in
30 hex – 3F hex.
C h e c k i n g V e r s i o n I n f o r m a t i o n
You can check the versions of both the printer’s hardware and firmware.
Syntax ESC-‘cmdfv’
ESC-‘cmdhv’
ESC Starts the command language.
‘cmdfv’ Request firmware version command. Enter P(.
ESC Starts the command language.
‘cmdhv’ Request hardware version command. Enter P).