Panasonic CF-W2 - Manual (Page 60)

Reinstalling Software
60
Troubleshooting
z To divide the hard disk into two partitions (for OS and data)
Press the
2
key.
Enter the basic partition size (GB) for the operating system installation
and press the
Enter
key.
• You can cancel this operation by pressing the
0
key.
• The data partition size is the remainder after subtracting the basic
partition size. (Data partition: 1 GB or more)
Maximum settable size differs depending on the model.
z To reinstall Windows in the original partition without changing the parti-
tion configuration
Press the
3
key.
• The first partition size must be 6 GB or more of the hard disk size.
Reinstallation cannot be performed with a small partition size.
If you select [1] or [2], the message [The Backup function has been enabled.
If [Recovery] is executed, the Backup function will be disabled, and your
Backup data will be lost.] appears. In this case, press the
Y
key.
If the message [Computer must be rebooted in order to execute [Recovery.]]
appears, press the
R
key.
D At the confirmation message, press the
Y
key.
z The operation of reinstallation for the hard disk starts automatically.
(The operations take about 20 minutes.)
z Do not interrupt the reinstallation procedure before completion, for
example by turning off the computer or pressing the
Ctrl
+
Alt
+
Del
key, as this may prevent Windows from starting up, or may cause data
to be lost so that the reinstallation procedure cannot be executed.
E The message "[Recovery] is complete" will be displayed. Remove the
Product Recovery DVD-ROM, and press any key to shut down the com-
puter.
4
Return the Setup Utility settings to their default values.
Return the Setup Utility to its settings at the time of shipment to ensure
proper setup of Windows.
A Turn on the computer, and press the
F2
key while [Panasonic] boot
screen is displayed.
The Setup Utility will start up.
If the password has been set, enter the Supervisor Password, and press
the
Enter
key.
B Press the
F9
key.
At the confirmation message, select [Yes] and press the
Enter
key.
C Press the
F10
key.
At the confirmation message, select [Yes] and press the
Enter
key.
The Setup Utility will close, and the computer will restart.