Pentax * istDL2 - Manual (Page 195)

193
6
Appe
ndix
In rare cases, the camera may not operate correctly due to static
electricity. This can be remedied by taking the batteries out and putting
them back in again. When the mirror remains in the up position, take the
batteries out and put them back in again. Then, turn the power on. The
mirror will retract. After the procedure is done, if the camera operates
correctly, it does not require any repairs.
* Refer to p.13 of the “PENTAX PHOTO Browser 2.1/PENTAX PHOTO
Laboratory 2.1 Operating Manual” for details on connecting the camera to a PC.
AE lock function
does not
operate
AE lock is not
available when set to
a
(Manual) mode or
p (Bulb) mode
Use AE lock with any setting other than a
(Manual) mode or p (Bulb) mode.
Flash does not
discharge
When flash mode is
set to [Auto
discharge] or [Auto
flash+Redeye
reduct], the flash will
not discharge if the
subject is bright
Set flash mode to [Manual discharge] or
[Manl flash+Redeye reduct]. (p.51)
Mode dial is set to
a
(Flash OFF)
Set mode dial to any setting other than
a
(Flash OFF). (p.47)
H (Scene) mode is
set to A (Night
Scene), K (Sunset),
D
(Candlelight) or
E (Museum)
Set H (Scene) mode to any setting other
than A (Night Scene), K (Sunset),
D
(Candlelight) or E (Museum). (p.47)
The power
zoom system
does not
function
The camera does
not have the power
zoom function
Use manual zoom. (p.50)
USB connection
with computer
does not work
properly*
The transfer mode is
set to [PictBridge]
Set transfer mode to [PC].
An error occurred
while sending USB
data
Change the transfer mode to [PC-F].
USB connection
with printer does
not work
properly
The transfer mode is
set to [PC] or [PC-F]
Set transfer mode to [PictBridge]. (p.85)
Problem Cause Remedy