Panasonic BT-LH1700WP - Manual (Page 16)

16
The underlined values are factory preset setting values.
*1 Even if FILM gamma is changed during 2 screen display, only the main window is set, and the changes are not
reflected in the sub window.
*2 When “RGB-COMP.” is selected in “YP
B
P
R
/RGB” in the “INPUT SELECT” menu ( J page 21), this does not operate.
*3 The following sharpness values can each be set,
1) VIDEO system input line (VIDEO,Y/C)(Factory settings are SHARPNESS MODE : LOW,
SHARPNESS H/V : 0)
2) any other input line’s HD (Factory settings are SHARPNESS MODE : HIGH, SHARPNESS H/V : 0)
3) any other input line’s SD (Factory settings are SHARPNESS MODE : LOW, SHARPNESS H/V : 0)
and the setting values for the selected input signal from within this group is displayed. The adjustment status is
displayed in the bottom right when selected.
*4 When “VAR1”, “VAR2” or “VAR3” is selected, the monitor switches to WB adjustment mode ( J page 17).
*5 When selecting USER0–63
1) Push [ENTER] (USER changes to blue). 2) Select 0–63 with [ , ], and push [ENTER].
VIDEO CONFIG
Sub menu Settings Explanation
GAMMA
SELECT
*2 *1
Used to select the gamma curve.
When FILM is selected,
mark is displayed in the top
left of the screen.
FILM GAMMA
*2
Used to select the type of FILM gamma mode.
VARICAM use
When using other types than VARICAM
COLOR TEMP. *5
Used to select the color temperature.
Adjustable settings 0–63 (color temperature
around 3000K–9300K)
Color temperature around 9300K
Color temperature around 6500K
Color temperature around 5600K
WB adjustment mode
*4
WB adjustment mode
*4
WB adjustment mode
*4
SHARPNESS
MODE
*2
*3
Used to select the width of the sharpness edge.
Thin edge Thick edge
SHARPNESS H
*2 <0–30>
*3
Used to set the sharpness in the horizontal direction.
When adjusting, the item display moves to the lower part of the
screen.
SHARPNESS V
*2 <0–30>
*3
Used to set the sharpness in the vertical direction.
When adjusting, the item display moves to the lower part of the
screen.
I-P MODE
*2 Used to set the mode for IP change.
Within Field Normal mode
MONO
*2 Used to switch between color and monochrome (MONO).
Color
Monochrome
* When this is ON, the picture adjusting knob [CHROMA] setting
is fixed at 0.
ANAMO
*2 If an Anamo lens has been used on the camera, and input through
SDI 720/60P, 59.94P, the picture is resized to Anamo size
magnification. (a vertically compressed signal can be amplified
vertically and corrected when it is displayed.)
SD ASPECT
*2 <4:3>
<16:9> Used for setting the aspect ratio settings when using SD signal
input.
<4:3>
4:3 display <16:9> 16:9 display
SCAN
*2 Used to set under-scan and normal display.
Normal display
Under-scan
NOISE WIPE
*2
This makes a fluid and smooth contrast obtainable.
This is especially effective for continuously changing the contrast
of the source signal or CG signal when the S/N is very high.
Noise reduction mode. Depending on the camera, this mode
can be especially effective for dark scenes. We recommend
leaving this setting “ON” under normal conditions.
Main Menu
(continued)