Polaroid FLM-3230TM - Manual (Page 55)

52
PROGRAMMING REMOTE CONTROL
Direct Device Code Setup
Although your Remote Control is set up to provide control of this
TV, you can specify other devices to be controlled, according to
the following steps:
Mode → <> (2 blinks) → 5- digit device codes (2 blinks)
STEP 1 Locate the desired device in the Device code list.
STEP 2 Select the mode by pressing VCR, CBL, or AUX.
STEP 3 Depress and hold <> button for a minimum of 3 seconds until LED blinks
twice.
STEP 4 Enter the 5-digit code for the desired device. The LED blinks once for every digit
entered except for the last digit, where it shall blink twice to confirm that a valid code
has been programmed.
Mode Device Assignment
Device
Group no.
TV Locked to this TV (Default) -------
VCR Universal VCR, DVD, PVR 2
CBL Universal Cable, Satellite, Video Accessory 0
AUX
Universal Tuner, Amplifier, CD, Mini Disc. And Misc. Audio,
Home Automation
3
Example: [VCR] →<> (2blinks)→[2]→[0]→[0]→[3]→ [5] (2 blinks).
NOTE 1: Each digit must be entered within 10 seconds, or the Remote Control shall exit programming state.
NOTE 2: Two short LED blinks indicate recognition of the code, after which device control via the remote is
enabled.
NOTE 3: A long LED display indicates non-recognition of the code, at which time the code should be
re-entered.