Panasonic KX-TG5453 - Manual (Page 63)

Useful Information
For assistance, please call 1-800-211-PANA (7262). 63
Caller ID
While storing an item in
the phonebook, the
handset starts to ring.
L
A call is being received. Answer the call and start again
from the beginning after hanging up.
Copying stopped with an
item displayed. L The destination handset may have lost communication
with the base unit, or the destination handset user may
have pressed {C} or {s}.
The displayed phonebook item was not copied to the
handset. Press {OFF}. Confirm that the destination
handset is in standby mode (i.e., not in use) and try
again.
The display exits the
phonebook while
searching. L The handset automatically exits after 1 minute of
inactivity.
Problem Cause & solution
The handset does not
display the caller’s name
and/or phone number.
L
You have not subscribed to Caller ID service. Contact
your telephone company to subscribe.
L If your unit is connected to any additional telephone
equipment such as Caller ID box or wireless telephone
jack, disconnect the unit from the equipment and plug
the unit directly into the wall jack.
L
If your unit is connected to a telephone line with xDSL
service, we recommend connecting a noise filter
between the base unit and the telephone line jack.
Contact your xDSL provider for details.
L The name display service may not be available in some
areas. Contact your telephone company for details.
L
Other telephone equipment may be interfering with this
unit. Disconnect the other equipment and try again.
L
The caller requested not to send caller information
(page 26).
L If a call is being transferred to you, the caller information
will not be displayed.
L
Generally caller information is displayed from the 2nd
ring.
The handset or base unit
does not announce the
displayed caller names. L The handset or base unit’s ringer volume is turned off.
Adjust it (page 38, 42).
L
The Talking Caller ID feature is turned off. Turn it on
(page 39, 43).
L
Caller names will usually be announced after the 2nd
ring.
L
The ring count for the answering system is set to “2” or
“Toll saver”. Select a different setting (page 54).
Problem Cause & solution
TG5451_5452_5453.book Page 63 Friday, February 18, 2005 11:38 AM