Polk Audio DP-1 - Manual (Page 31)

www.polkaudio.com 7
Manual Three-Digit Code Method
The DR-3 remote control can duplicate the remote functions of most
brands of audio/video equipment by simply entering in a three-digit
code number. When you enter in the code the DR-3 “learns” most or all
of the remote functions of that equipment so you don’t need to program
the DR-3 button by button. There are tables on pages 14 - 15 that list
the major audio/video brands and their three-digit remote codes.
Quick Instructions
1. Look up code number
2. Turn on equipment
3. Press and hold CODE until the Status Light glows red
4. Press Source/Device button
5. Enter code number
6. Press SAVE
Detailed Instructions
1. Look up the type and brand of equipment you wish to duplicate in
the tables that appear on pages 14 - 15 in this manual. For exam-
ple, if you wish to program the DR-3 to operate a Panasonic VCR,
go to the VCR chart on page 15 and find the code(s) for Panasonic.
It might be a good idea to jot that number down on this page so you
have it handy as you move through the programming steps.
Note: If there is more than one three-digit number listed for your
brand, try one code number at a time until your equipment turns
off after the last step in the programming process. When your
equipment turns off, you have selected the right code. You can also
verify that you have programmed the correct three-digit number by
pressing the SOURCE POWER button. Your equipment should turn
On and Off.
2. Turn on the equipment you wish to program.
NOTE: From here on in you have 20 seconds to perform each step.
If the Source/Device button light goes off, you need to back up a
step and do it again. You can exit the set-up mode by pressing the
CNCL (cancel) button at any time in the process.
3. Press and hold the CODE button for two seconds. The red status
light at the top left of the remote will turn on.
4. Press the Source/Device button you wish to program (e.g. VCR,
DVD, etc.). The Source button will light up. In the case of the
Panasonic VCR example, you would push the VCR Source button.
5. Point the Polk DR-3 remote control toward the equipment and enter
the first listed three-digit code number of your brand of equipment.
The Status light and the Source/Device button will blink once for
each button pressed. The equipment will turn off when you enter
the correct three-digit number.
6. Press and hold the SAVE button for 2 seconds to store the three-
digit number. The Status light and the Source/Device button light
will blink twice to confirm that the code has been stored, and then
turn off.
7. Try all the functions on the remote control.
NOTE: If any of the functions do not work as they should, repeat
the programming process using the next three-digit code number
assigned to your brand. If only one or two buttons don’t work right,
it may be easier to individually “teach” the DR-3 those commands
(see page 9) or use the Auto Search method (see page 8) rather
than trying all the three-digit codes.
PROGRAMMING THE REMOTE
4
5
3
6