Planet Technology IAD-300 - Manual (Page 5)

Rear Panel
Rear Panel Port and Button Definition
Connector Description
POWER
Button
The Power Button is for turn on or turn off the router.
Power Power connector with 12V DC 2A
USB1 Connect to USB Storage device to USB1 for FTP application.
USB2
Connect your Printer to USB2, the IAD-300 supports the built-in
Printer Server.
LAN 1-4
Router is successfully connected to a device through the
corresponding port (1, 2, 3, or 4). If the LED is flashing, the
Router is actively sending or receiving data over that port.
Reset
The reset button can restore the default settings of device. To
restore factory defaults, keep the device powered on and push a
paper clip into the hole. Press down the button over 5 seconds
and then release.
VoIP 1/2 Connect to any analog telephone for VoIP application.
DSL Line
The RJ-11 connector allows data communication between the
modem and the ADSL network through a twisted-pair phone wire.