Philips DVD763SA/001 - Manual (Page 15)

Diagnostic Software, Trouble Shooting and Test Instructions EN 30 DVD763SA 5.
SMA Error Codes
5.6.2 Reprogramming of New Mono Boards.
Figure 5-35 Reprogamming code
0008 SP_CONTINU
ITYERROR Sequence of sectors coming
from disc is incorrect. Reason:
see SP_SYNCERROR
0009 DMX_CONTI
NUITYERRO
R Sequence of sectors is incorrect.
Reason: problem with buffer
RAM
000A LLD_ERROR An illegal audio format was
offered to the decoder. Reason:
unknown audio type on disc or
problem with buffer RAM
000B BCU_ERROR Internal problem in Furore chip
Error
Code
Error name Explanation Error
Number Error name
Explanation
0000 SMA_TIMEO
UTERROR Data coming from disc not in
time. Reason: damaged disc or
engine problem.
Caution
This information is confidential and may not be distributed. Only a qualified service person should
reprogram the mono board .
After reset of NV-memory or repair of the mono board, all the customer settings and also the region code
will be lost.
Reprogramming of the mono board will put the player back in the state in which it has left the factory,
i.e. with the default settings and the allowed region code.
Reprogramming will be done by way of the remote control.
Put the player in stop mode, no disc loaded.
Reprogramming is limited to 25 times
When the counter reaches 25, reprogramming is not possible anymore
Press the following keys on the remote control:
<
PLAY > followed by numerical keys <1> <5> <9>
The display shows: “ - - - - - - - - - - - ”
Press now successively the following keys :
for DVD763SA /001 /021 /051 : <2><2><2> <0><0><8><0><0>
Press < PLAY > again.
The TV screen will become BLUE during a short time to confirm that the mono board has been
reprogrammed.
CL 26532053_056.eps
150502