Philips DVD763SA/001 - Manual (Page 10)

Diagnostic Software, Trouble Shooting and Test Instructions EN 25 DVD763SA 5.
In this example 23 is the hexidecimal code of the pressed RC
key. The user can leave the remote-control test by pressing
PLAY on the local keyboard of the DVD player. The remote
control test is successful if a code was received before the user
pressed the PLAY key. Pressing the PLAY key, before
pressing a key on the remote control, gives an error in the
remote control test (note that the remote control test will also
fail if a key on the remote control was pressed but no code was
received). The remote control test does not check upon the
contents of the received code, that is it will not be checked if the
received code matches the key pressed. If desired, the user
can manually check this code by using a code-table for the
remote control key-codes.
Figure 5-12
After pressing PLAY, the result of the remote control test is
displayed on the local display of the DVD player as follows:
Figure 5-13
Or
Figure 5-14
Pressing PLAY on the local keyboard again will proceed to the
next test.
5.3.5 P50 Loop-Back Test
For the P50 loop-back test, the user must first press a key to
decide if the test is to be performed.
The display will show the following message:
Figure 5-15
If the user presses STOP, the P50 test will be skipped.
If the user presses OPEN/CLOSE, the P50 test is performed
and the result is displayed as follows:
Test successful:
Figure 5-16
Test fails:
Figure 5-17
Press the PLAY key to continue to the next text
RC Key id Hexadecimal code
STANDBY 0C
1 1
2 2
3 3
4 4
5 5
6 6
7 7
8 8
9 9
0 0
RETURN 83
DISPLAY EF
DISC MENU 54
SYSTEM MENU 82
CURSOR UP 58
CURSOR DOWN 59
CURSOR LEFT 5A
CURSOR RIGHT 5B
OK 5C
PREVIOUS 21
NEXT 20
STOP 31
PLAY 2C
PAUSE 30
SUBTITLE 4B
ANGLE 85
ZOOM F7
AUDIO 4E
REPEAT 1D
REPEAT A-B 3B
SHUFFLE 1C
SCAN 2A
CL 16532162_037.eps
080102
CL 96532065_013.eps 120799
CL 96532065_014.eps
120799
CL 16532007_004.eps 090102
CL 16532007_005.eps 090102
CL 16532007_006.eps 090102