Internal scsi ribbon cable to host adapter – LSI Ultra160 User Manual
Page 21
Connecting SCSI Peripherals
2-5
Step 1.
Plug the 68-pin connector on the SCSI ribbon cable into the
internal connector on the host adapter board.
illustrates how to make this connection.
Figure 2.3
Internal SCSI Ribbon Cable to Host Adapter
Step 2.
Plug the 68-pin connector on the other end of the internal SCSI
ribbon cable into the SCSI connector on the internal SCSI
device.
illustrates the chaining of internal SCSI
devices.
If you have more than one internal SCSI device, you must have
a cable with at least as many connectors as you have devices.
Note:
Daisy chaining devices represent an arrangement of
devices connected in a series. Any signal transmitted to the
devices goes to the first device, from the first to the second,
and so on. Termination occurs on the last internal SCSI
device.
See
Section 2.3, “Terminating the SCSI Bus,”
for more
information on SCSI bus termination.
68-Pin
Connector
Internal
Connectors
68-Pin High Density Ribbon Cable
(See
and
for
examples of internal ribbon cables.)