Lennox Hearth II-T C FS - Manual (Page 31)

SPECIFICATIONS - Advantage II-T C FS
PAGE 31
Flue Size 3” Standard
Width, Overall 24 3/4”
Depth, Overall 25” (26" to flue outlet)
Depth, Overall w / 3” tee 30 7/8”
Height 31 3/8”
Floor to Rear
Flue
Center 17 1/2”
Facing Back of Unit,
outside edge on right
to center of rear
flue
outlet 5 15/16”
Floor to Rear
Outside Air Inlet
11"
Facing Back of Unit
outside edge on right
to center of air inlet
13 1/2”
Floor Protection + 6" Front & Sides
Requirements & up to * 6” for the Back
Standard Features
Fastfire  Self Igniter
Wall Thermostat
(wire included)
Hopper Capacity 70 lbs.
Burn time
♦ 15.5 - 54 hours
Fuse, Control Board 5 Amp, 250 volt, 3AG *
Fuse, Igniter 6 Amp, 250 VAC *
Heat Input (Max.)
♦ 11,000 - 38,000 BTU / hr
Emissions
♦ 2.3 gr / hr (varies w / size
and type of fuel) EPA
Certified
Ship Weight 225 lbs.
Room Air Blower
150 CFM;1.5 Amps,
3000 rpm
Auger Motor 1 RPM; .55 Amps
Exhaust Blower
95 CFM: .95 Amps,
3000 rpm
Options Log Set
Gold Trivet
SIDE VIEW ILLUSTRATION
BACK VIEW ILLUSTRATION
Note: Dimensions shown are approximations only (+/-
1/4”)
+ Non-combustible thermal rated floor protection must
be used when installed on carpet (see Floor Protec-
tion, page 5). When installed at clearances less
than 6”, the floor protector is only required to ex-
tend to the wall.
♦ Fuel delivery and burn times will vary depending
on size and type of fuel used. Estimated heat in-
put based on fuel value of 8400 BTU per lb. Fuses
are rated as fast blow.
24 3/4”
5 15/16"
30 7/8”
25”
24 3/4"
7 9/16"
13 1/2"
9"
11"
17 1/2"
31 3/8"
www.PelletKing.com