Linksys WAPPOE - Manual (Page 9)

Chapter
Connection
PowerOverEthernetAdapterKt
Chapter:Connecton
Overview
This chapter gives instructions on how to connect the Power Over
Ethernet Kit. Once connected, the Kit will transmit data and power over
the Ethernet network cable to your remotely located network device.
The diagram shows an example of how the Kit can be connected to a
wired switch and a wireless access point.
Power Adapter
(24V typical)
Injector Splitter
Power Over Ethernet
Ethernet Cable
Network
Workgroup
Switch
Wireless
Access Point
Ether
net C
able
Ether
net C
able
Power Cable
Power Cable
Up to 328 feet
(100 m)
To connect the Kit to a device with a conventional power port, proceed
to the section, “Power on a Device that Uses a Standard Power Adapter.”
To connect the Injector to a device that supports inline power, proceed
to the section, “Power on a Device that Uses Inline Power.”