La Crosse Technology WS-6002U - Manual (Page 6)

search after 10 minutes if the time is not found. When the
search is cancelled “-:--”will appear in the time LCD. The
Atomic Clock will conduct a WWVB search every hour until the
first signal is found. Once the WWVB time is found, a search is
automatically conducted nightly at midnight. If the signal is
found at midnight, the tower icon will remain, if not, another
search will take place every hour (up to 6:00 am) until the
signal is found successfully. If no signal is found during this
period, the tower icon will not appear and the clock will search
again at 12:00 am the next night.
WWVB Tower Icon
Indoor
Temperature Weekday Month/Date
PROGRAM MODE
To enter the Program Mode hold down the “SET” button for 2
seconds, until “-5EST” flashes in the Date LCD. The Program
Mode is laid out in a manner that allows you to program each
function separately, or you can follow the instructions entirely to
program the Atomic Clock. Complete programming is usually
done for the initial set-up, and will require you to skip step 1 of
programming sections III through VIII. Wait approximately 15
seconds for the Atomic Clock to automatically return to normal
operation.
I) FUNCTION
BUTTONS
There are 2 function buttons located on the backside of the
Atomic Clock. The function buttons are labeled: SET and +.
6