3 ups intelligent communications, Ups intelligent communications, Caution – Liebert GXT2-6000RTL630 User Manual

Page 29

Communications

10.3 UPS Intelligent Communications

The GXT2-6000RTL630 is equipped with two Intellislot® ports to provide advanced communication

and monitoring options.
The Intellislot port closer to the corner of the UPS chassis is the serial card slot. This Intellislot port is

used for the OCWEBCARD and the USBCARD. The other Intellislot port is used for

RELAYCARD-INT or the MULTIPORT Card.

Liebert's MultiLink software continually monitors the UPS and can shut down your computer or

server in the event of an extended power failure.
MultiLink can also be configured for use without the serial cable when the Intellislot SNMP/Web card

is installed in the UPS. Additionally, MultiLink can be configured to coordinate shutdown across the

network with other computers running MultiLink when you purchase a MultiLink License Kit. For

more information about the Intellislot SNMP/Web Card and MultiLink license Kits, visit our Web site

(www.liebert.com) or contact your local dealer or Liebert representative.
Several option cards are available for use in the Intellislot port of the GXT2-6000RTL630. The Intel-

lislot SNMP/Web Card provides SNMP and Web-based monitoring and control of the UPS across the

network.
The Intellislot MultiPort 4 Card allows you to install MultiLink software on four computers and coor-

dinate shutdown in the event of a power failure.
The Intellislot Relay Card provides dry contact relay outputs for custom wired applications and deliv-

ers support for built-in shutdown for AS/400 systems.

NOTE
The OCWEBCARD DB9 serial port cable should be used only for the initial card setup. Remove

the cable after setup is complete.
When the DB9 OCWEBCARD serial port cable is removed, the OCWEBCARD DB9 connector

needs to be covered. The DB9 cover is included with the UPS.

CAUTION

To maintain safety (SELV) barriers and for electromagnetic compatibility, signal cables

should be segregated and run separate from all other power cables, where applicable.

DB9 (RS232) port

covered

Liebert’s OCWEBCARD