Linear 3060 User Manual

Linear Satellite

location of both the transmitter and receiver will affect
the range. If the transmitter is stowed well out of sight, it
may be necessary to remove it from its mounting and
hold near the windshield. Try different locations and
positions. If operation is still unsatisfactory, the problem
may be isolated by:

1 . Checking the door operator. If the door will not

open when the wall button is pressed, the problem
is likely to be the operator. If the door will open by
pressing the wall button, but not when the radio
control button is pressed, the problem is probably in
the radios.

2. Replacing the transmitter battery. If, after perform-

ing the above operational checks, the controls still
do not function, they should be returned to your
dealer for repair or replacement.

CAUTION:

Any changes or modifications in intentional or

unintentional radiators which are not expressly approved by
LINEAR CORPORATION could void the user’s authority to
operate this equipment. This applies to intentional and
unintentional radiators certified per part 15 of the F.C.C.
rules and regulations.

This device complies with FCC Part 15 and Industry Canada
Rules and Regulations. Operation is subject to the following
two conditions: (1) This device may not cause harmful
i n t e r f e r e n c e , a n d ( 2) T his de v i c e m u s t a c c e p t a n y
interference received, including interference that may cause
undesired operation.

LINEAR CORPORATION

2055 Corte Del Nogal

• Carlsbad, CA 92009

214942 B

INSTALLATION INSTRUCTIONS

MINI-TRANSMITTER MODEL 3060

Congratulations! You have just purchased a Mini-Code
Digital Transmitter, which we believe to be the finest
product of its kind on the market. With a little care this
transmitter should provide you with many years of
excellent service. Please take a moment to read the
following instructions and you will find that setting your
new transmitter will be quite an easy matter.

ACCESSING THE CODE SWITCH AND BATTERY
COMPARTMENT

The model 3060 Mini-Transmitter case is composed of 2
halves which are held together by a small phillips head
screw. Removing this screw will allow access to both the
code setting switch and the battery compartment. (see
diagram #1)

INSTR,INSTL,MC3060,MINI-TX
LINEAR P/N: 214942 B
INK: BLACK
MATERIAL: 20 LB. MEAD BOND
SIZE: 6.250" x 4.500"
SCALE: 1-1
SIDE 1 OF 2