Lowrance electronic GlobalMap 3300C - Manual (Page 53)

47
4. Press
↓ to
L
ONGITUDE
| ENT . Enter the longitude by pressing
↑ or ↓ to
change the first character, then press
→ to the next character and repeat
until the longitude is correct. Press ENT , then EXIT | EXIT to return to the
previous page display. The waypoint is saved and automatically given a
name with a sequential number, such as "waypoint 001." The waypoint
symbol and number appear on the map and in the waypoint list.
Navigate To a Waypoint
You can select any waypoint visible on the Map Page with the cursor,
then use the Navigate to Cursor command (we'll describe how later in
this section.) However, you can avoid scrolling the map to pick your
waypoint if you use the Find Waypoint commands:
1. Press WPT |
↑ to
M
Y
W
AYPOINTS
| ENT . To look up the nearest waypoint,
press
↓
to N
EAREST
| ENT ; or, to look by name (and scroll through the en-
tire waypoint list), press ENT . For this example, look by name.
2. If your waypoint list is a long one, you can spell out the waypoint name
in the
F
IND
B
Y
N
AME
box to search for it. (Press
↑ or ↓ to change the first
character, then press
→ to move the cursor to the next character and re-
peat until the name is correct, then press ENT to jump to the list below.)
3. If the list is short, you can jump directly to the F IND I N L IST
box by
pressing ENT . Use
↑ or ↓ to select the waypoint name, press
ENT and the
waypoint information screen appears with the G
O
T
O
command selected.
4. To begin navigating to the waypoint, press ENT .
Navigation Page, navigating toward waypoint 001 and leaving a trail.
Waypoint
Destination
name
Trail line
(magenta)
Course line
(red)
Off course
range, set at
0.15 mile