Lowrance electronic GlobalMap 3300C - Manual (Page 20)

14
GPS module mounting template.
After the module is installed, connect it to the unit. The LGC-2000 can
communicate with your GPS unit either directly (using the supplied ex-
tension cable) or through a NMEA 2000 network.
Connecting Directly to the Unit
After the module is installed, attach it to the end of the Y-adapter ex-
tension cable as shown in the following diagram. To connect it to the
unit, insert the extension cable's splitter plug into the Network socket
on the back of the unit and your system is ready to use.
LGC-2000 direct connection to GPS unit.
25' Y-adapter
extension cable
60-ohm
terminator
LGC-2000
To unit
Splitter plug
Drill size 3/16" (4.75 mm)
Drill four places.
Drill size 1" (25 mm )
(If needed.)