Linksys SPA 900 Series - Manual (Page 83)

3-40
Linksys IP Phone Administrator Guide
Firmware Version 5.1
Chapter 3 Managing Linksys IP Phones
System Administration
• Call Forward Busy (*90)—Call forwards on busy. Applies to primary extension only:
• Cancel Call Forward Busy (*91)—Cancels call forward on busy. Applies to primary extension only.
• Call Forward No Answer (*92)—Call forwards if no answer. Applies to primary extension only.
• Cancel Call Forward No Answer (*93)—Cancels call forward no answer. Applies to primary
extension only.
• Block Caller ID Always (*67)—Blocks caller ID on all outbound calls. Applies to all extensions.
• Block Caller ID Per Call (*81)—Blocks caller ID on the next outbound call (on the current call
appearance only).
• Unblock Caller ID Always (*68)—Unblocks caller ID on all outbound calls. Applies to all
extensions.
• Unblock Caller ID Per Call (*82)—Unblocks caller ID on the next outbound call (on the current call
appearance only).
• Secure All Calls (*16)—Defaults to prefer to use encrypted media (voice codecs).
• Secure No Calls (*17)—Defaults to prefer to use unencrypted media for all outbound calls. Applies
to all extensions.
• Secure Next Call (*18)—Prefers to use encrypted media for the next outbound call (on this call
appearance only).
• Do Not Secure Next Call (*19)—Prefers to use unencrypted media for the next outbound call (on
this call appearance only).
• Do Not Disturb (*78)—Applies to all extensions.
• Cancel Do Not Disturb (*79)—Applies to all extensions.
• Block Anonymous Calls—Applies to all extensions.
• Cancel Block Anonymous Calls—Applies to all extensions.
• Blind Transfer (*98)—This allows you to transfer a call to another person without talking to that
person:
a. Put the call on hold
b. Get a dial tone on another line
c. Call the person to whom you are transferring the call by pressing *98, followed by their
extension
d. Hang up the receiver
• Prefer G.711u (*017110)—Sets preferred codec to G.711u for next outbound call.
• Prefer G.711a (*017111)—Sets preferred codec to G.711a for next outbound call.
• Prefer G.723 (*01723)—Sets preferred codec to G.723 for next outbound call.
• Prefer G.726r16 (*0172616)—Sets preferred codec to G.726r16 for next outbound call.
• Prefer G.726r24 (*0172624—Sets preferred codec to G.726r24 for next outbound call.
• Prefer G.726r32 (*0172632)—Sets preferred codec to G.726r32 for next outbound call.
• Prefer G.726r40 (*0172640)—Sets preferred codec to G.726r40 for next outbound call.
• Prefer G.729a (*01729)—Sets preferred codec to G.729a for next outbound call.
• Force G.711u (*027110)—Forces G.711u for next outbound call.
• Force G.711a (*027111)—Forces G.711a for next outbound call.
• Force G.723 (*02723)—Forces G.723 for next outbound call.
• Force G.726r16 (*0272616)—Forces G.726r16 for next outbound call.