Linksys SPA 900 Series User Manual
Page 129
5-24
Linksys IP Phone Administrator Guide
Firmware Version 5.1
Chapter 5 Linksys IP Phone Field Reference
Regional Tab
Secure One Call Act Code
Makes the next outbound call secure. (It is redundant if all outbound calls are secure by
default.)
Defaults to *18.
Secure One Call Deact Code
Makes the next outbound call not secure. (It is redundant if all outbound calls are not
secure by default.)
Defaults to *19.
Paging Code
The star code used for paging the other clients in the group.
Defaults to *96.
Call Park Code
The star code used for parking the current call.
Defaults to *38.
Call Pickup Code
The star code used for picking up a ringing call.
Defaults to *36.
Call UnPark Code
The star code used for picking up a call from the call park.
Defaults to *39.
Group Call Pickup Code
The star code used for picking up a group call.
Defaults to *37.
Media Loopback Code
The star code used for media loopback.
Defaults to *03.
Referral Services Codes
These codes tell the Linksys IP phone what to do when the user places the current call on
hold and is listening to the second dial tone.
One or more *code can be configured into this parameter, such as *98, or *97|*98|*123,
etc. Max total length is 79 chars. This parameter applies when the user places the current
call on hold (by Hook Flash) and is listening to second dial tone. Each *code (and the
following valid target number according to current dial plan) entered on the second
dial-tone triggers the Linksys IP phone to perform a blind transfer to a target number that
is prepended by the service *code.
For example, after the user dials *98, the Linksys IP phone plays a special dial tone called
the Prompt Tone while waiting for the user the enter a target number (which is checked
according to dial plan as in normal dialing). When a complete number is entered, the
Linksys IP phone sends a blind REFER to the holding party with the Refer-To target
equals to *98
to an application server to perform further processing, such as call park.
The *codes should not conflict with any of the other vertical service codes internally
processed by the Linksys IP phone. You can empty the corresponding *code that you do
not want to Linksys IP phone to process.
Field
Description