Installation – Lincoln Electric POWER FEED IM584-D User Manual
Page 16
A-8
INSTALLATION
POWER FEED 10
A-8
MSB - Most Significant Bit or Byte. This is the bit in a binary number or DIP switch bank that is furthest to the left.
LSB - Least Significant Bit or Byte. This is the bit in a binary number or DIP switch bank that is furthest to the right.
S2 DIP Switch Bank on Control Box Motherboard (For software version S24004-3 & up)
Switch
Off
On
1
Network Group ID, MSB (Assigns Control Box to a specific group) (Off is factory setting)
2
Network Group ID, LSB (Assigns Control Box to a specific group ) (Off is factory setting)
3
Spare
4
Spare
5
Spare
6
Must be off for normal operation
Adjust lower limits
7
Must be off for normal operation
Adjust upper limits
8
Must be on for European units only
Note: the factory shipped settings for all of the S1 and S2 switches is “OFF”.
S1 DIP Switch Bank on Control Box Motherboard (For software version S24004-2 only)
Switch
Off
On
1
US 4-Step Trigger Logic
Euro 4-Step Trigger Logic
2
WFS Display = inches/minute
WFS Display = meters/minute
3
Left Display is always preset WFS
Left Display is preset WFS when weld current is not flowing
Left Display is actual weld current when weld current is flowing
CC modes override this switch regardless of position. Left Display is always preset weld cur-
rent when weld current is not flowing and actual weld current when weld current is flowing
4
Run-in = Minimum Speed Available
Run-in = weld WFS
If any option containing a Run-in setting is connected to the motherboard, it automatically
overrides this switch regardless of position.
5
Spare
6
Acceleration, MSB (Sets acceleration rate for wire drive) see below
7
Acceleration (Sets acceleration rate for wire drive) see below
8
Acceleration, LSB (Sets acceleration rate for wire drive) see below