Linksys SLM2005 - Manual (Page 16)

Chapter Advanced Configuration
1 5-Port and 8-Port 10/100/1000 Ggabt Smart Swtches wth PD and AC Power
System Prorty Bridge priority is used in selecting the
root device, root port, and designated port. The device
with the highest priority becomes the STA root device.
However, if all devices have the same priority, the device
with the lowest MAC address will then become the root
device. The default value is 68. The range is 0 to 61440
in steps of 4096.
Hello Tme Interval (in seconds) at which the root device
transmits a configuration message. The default is
seconds. The range is 0 to 10 seconds.
Max Age The maximum time (in seconds) a device can
wait without receiving a configuration message before
attempting to reconfigure. The default max age is 0
seconds. The range is 6 to 40 seconds.
Forward Delay The maximum time (in seconds) this
device will wait before changing states (i.e., discarding
to learning to forwarding). The default is 15 seconds. The
range is 4 to 30 seconds.
STP Port Settings
Port Displays the port number.
Enable STP Indicates if STP is enabled on the port.
Port Fast Indicates if Port Fast is enabled on the port.
If Port Fast mode is enabled for a port, the Port State
is automatically placed in the Forwarding state when
the port link is up. Port Fast optimizes the STP protocol
convergence.
Path Cost The path cost is used to determine the best
path between devices. The default value is auto.
Click Save Settngs to save any changes.
STP > STP Status
From the STP Status screen, you will see the STP Status for
each VLAN Bridge, and for each port.
STP > STP Status
STP VLAN Bridge Overview
VLAN ID The VLAN ID that has been assigned to the
interface.
Brdge ID A unique identifier for this bridge, consisting of
the bridge priority and MAC address (where the address is
taken from the Switch system).
Hello Tme Displays the Hello Time value as defined on
the STP > STP Settings screen.
Max Age Displays the Max Age value as defined on the
STP > STP Settings screen.
Fwd Delay Displays the Forward Delay value as defined
on the STP > STP Settings screen.
Topology Displays the topology.
Root ID The Root ID is displayed here.
STP Port Status
STP Status on each interface since the device was last
refreshed.
Port The number of the port.
VLAN The VLAN that has been assigned to the port.
Path Cost The best path between devices.
Port Fast Indicates the device is the end for a switch
connection.
Port State Indicates if the STP is disabled or enabled on
the interface.
Statistics > Statistics Overview
You can display standard statistics on network traffic for
each port of the device.
From the Statistics Overview screen, you will see the
standard statistics for each port of the device. Use the
Refresh button to update the statistics.
Statistics > Statistics Overview
Port Displays the port that the data applies to.
Tx Byte Displays the number of octets transmitted on the
port since the device was last refreshed.
Tx Frames Displays the number of frames transmitted on
the port since the device was last refreshed.
Rx Bytes Displays the number of octets received on the
port since the device was last refreshed.