Linksys SLM2005 - Manual (Page 11)

Chapter Advanced Configuration
5-Port and 8-Port 10/100/1000 Ggabt Smart Swtches wth PD and AC Power
Port > LACP Settings
Port Displays the port number.
Enable LACP Enables LACP.
Admn Key A channel will only be formed between ports
having the same admin key. This only applies to ports
located on the same switch. The default setting is auto.
Click Save Settngs to save any changes.
Port > LACP Status
From the LACP Status screen, you will see the LACP Status
for each port, and its partner port number, and operational
port key.
Port > LACP Status
LACP Port Status LACP Status on each interface since
the device was last refreshed.
Protocol Actve Indicates if the LACP is disabled or
enabled on the interface.
Partner Port Number Indicates the port that is in the
same LAG group.
Operatonal Port Key A channel will only be formed
between ports having the same operational port key. This
only applies to ports located on the same switch.
VLAN > VLAN Settings
A VLAN is a group of ports that can be located anywhere
in the network, but communicate as though they belong
to the same physical segment. VLANs help to simplify
network management by allowing you to move devices
to a new VLAN without having to change any physical
connections. VLANs can be easily organized to reflect
departmental groups (such as Marketing or R&D), usage
groups (such as e-mail), or multicast groups (used for
multimedia applications such as videoconferencing). You
can create up to 16 VLANs on the Switch.
To create a single VLAN, enter the VLAN ID, and click Add.
Use the VLAN ID screen to configure port members or LAG
members for a specific VLAN index.
VLAN > VLAN Settings
VLAN ID ID of configured VLAN (1-4094, no leading
zeroes).
To remove a VLAN, select the VLANs in the VLAN list, then
click Delete.
Click Save Settngs to save any changes.
VLAN > VLAN Port Settings
You can configure VLAN behavior for specific interfaces,
including the mode, accepted frame type, VLAN identifier
(PVID), and ingress filtering.
VLAN > VLAN Port Settings