Lennox Hearth BELLA-PK-TB User Manual

Page 2

P/N 506033-11 REV. NC 12/2008

Lennox Hearth Products reserves the right to make changes at any time, without notice, in design,

materials, specifications, prices and the discontinuance of colors, styles and products. Consult

your local distributor for fireplace code information.

NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.

Step 3. Hold the right side door closed tightly while you carefully return the

front cast iron door to the closed position, paying special attention

to the narrow gap between the two doors (A in Figure 3).

Figure 3

Step 4. With the side door open, using your 1/8” allen wrench, remove the

screws attaching the top side panel bracket and set aside for step 6.

Step 5. Loosen the screws attaching the lower panel bracket enough to

remove the sheet metal panel. With bracket still loose, place the

stone panel between the bracket and door.

Step 6. Hold new stone panel in place while reattaching the upper side

panel bracket. Snug down upper and lower screws taking care not

to over-tighten.

CAUTION: OVER-TIGHTENING THE PANEL BRACKETS MAY RE-

SULT IN DAMAGE, CRACKS ETC TO THE STONE PANELS. SNUG

ONLY!

Step 7. Repeat step 6 on opposing side.

Step 8. To re-secure right side door, make sure the front cast iron door is

fully closed, close the right side door and while holding it tightly

shut carefully open the front door again and re-secure right side

door to the firebox (see Figure 2). Once secure, check the clearance

between the front and side castings by carefully opening the front

door, adjust the side door screws accordingly.

Step 9. When you are finished installing the panels in the sides, repeat the

same sequence on the front door. Do not over tighten!

Figure 4

Figure 5

DO NOT OVERTIGHTEN SCREWS! SNUG ONLY!

1110 West Taft Avenue • Orange, CA 92865

DO NOT OVERTIGHTEN SCREWS! SNUG ONLY!

This manual is related to the following products: