Lantronix MSS - Manual (Page 47)

Command Reference Change Password Protect
2-38
2.44 Change Password Protect
Controls whether a password is needed to log into the MSS from a serial port. For models with a dedicated
console port (the MSS-Via, MSS485, and the MSSLite A and C), this command will also affect the serial
console port. To set the login password, use the Change Loginpass command.
Restrictions Requires privileged user status.
Parameters Port
MSS4 only. Specifies a particular port or group of ports.
Note: In the absence of the PortList parameter, the configuration will affect the MSS4’s
current port only.
PortList
Specify a particular port or group of ports. Port numbers are specified with
integers between 1 and 4, and should be separated with commas (for lists) or
dashes (for ranges).
Defaults Disabled
See Also Change Loginpass, page 2-31.
2.45 Change Portname
Renames the specified serial port.
Restrictions Requires privileged user status.
Parameters Port
MSS4 only. Specifies a particular port or group of ports.
Note: In the absence of the PortList parameter, the configuration will affect the MSS4’s
current port only.
PortList
Specify a particular port or group of ports. Port numbers are specified with
integers between 1 and 4, and should be separated with commas (for lists) or
dashes (for ranges).
name
Enter a 16-character name composed of alphanumeric characters or the
underscore character. Enclose the name in quotation marks to preserve case.
Defaults Port_1 (also Port_2, Port_3, and Port_4 for MSS4 only)
CHANGE PORT PortList PASSWORD PROTECT
DISABLED
ENABLED
 
 
 
CHANGE PORT PortList PORTNAME name