Lennox Hearth Crestline LSBV-3628MN - Manual (Page 13)

13
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
LENNOX HEARTH PRODUCTS • CRESTLINE™ SERIES B-VENT GAS FIREPLACES • 36"/42" LSBV MODELS • INSTALLATION INSTRUCTIONS
Figure 19
These appliances are equipped with a beautifully
crafted six (6) piece ceramic fiber log set. The
logs are to be positioned precisely as shown.
Any modification to the lay of the logs may result
in sooting, property damage and injury or death.
The rear log has mating holes for pin engage-
ment on its bottom side. DO NOT force a hole
into a log by engaging the pins where they are
not intended to go.
Apparent minor mis-alignment of the pins and
holes or landings can be eliminated by gently
adjusting the position of the logs until the pins,
holes or landings easily mate.
Step 1. To position the logs, begin by placing
the rear log in position over the two pins located
at the left rear and right rear of the log grate,
see Figure 18 and Figure 20.
Figure 20
Rear Log
Step 2. Position the bottom log, (see Figure
18 and Figure 21) between the two vertical
brackets of the burner tray.
Remove the Glowing Embers from the plas-
tic bag and tear into quarter size pieces, as
shown in Figure 21. Spread across the front
part of the burner. Do Not use more than is
necessary to cover the burner. When properly
positioned, the Glowing Embers will unevenly
cover approximately 85% of the burner with no
appreciable gaps.
Figure 21
Bottom Log
Log Grate Glowing Embers
Figure 22
Figure 23
Step 3. Place the left log as shown in Figure
22, on the landing of the rear log. Make sure
the landing on the front end of the log is resting
on the first left finger of the grate, as shown
in Figure 22.
Step 5. Place the right log as shown in Figure
24, with the upper end sitting on the landing
provided on the rear log. Another end of the
right log should rest on the first right finger
of the grate (see Figure 24). Position the top
right log as shown, locating it on the landing
of the center log.
Step 4. Position the center log, see Figure 23,
with the two branches sitting on the two landings
provided on the top of the left log. The other
end of the center log has a groove that should
fit against the second right finger of the grate,
as shown in Figure 23.
Figure 24
Left Log
Center Log
Right Log
Right Grate Finger
Top Right Log
Center Log Landing
Left Grate Finger
Second Right Grate Finger
Left Log Landings
Rear Log Landing