Life Fitness G7 - Manual (Page 7)

7
NOTE: Two person assembly is recommended.
STEP 1:
Make sure the LEFT TOWER (1) and the RIGHT TOWER (11) are positioned correctly prior to assembly. The LEFT
U BRACKET (A) and RIGHT U BRACKET (B) should point towards each other as shown in the above illustration.
Use four M10 x 20mm SCREWS (26) and four M10 WASHERS (27) to connect the BOTTOM BRACKET TUBE (4)
to the LEFT TOWER (1). Finger tighten only.
NOTE: THE BOTTOM BRACKET TUBE (4) HAS A RUBBER PAD ATTACHED TO IT TO MAKE CONTACT WITH THE
FLOOR.
Repeat the above process using the TOP BRACKET TUBE (2) and the MIDDLE BRACKET TUBE (3).
NOTE: THE TOP BRACKET TUBE (2) DOES NOT HAVE ANY HOLES. THE MIDDLE BRACKET TUBE (3) HAS
THREE HOLES THROUGH THE TOP AND BOTTOM.
Repeat all of the above steps to attach the TOP (2), MIDDLE (3), and BOTTOM (4) BRACKET TUBES to the RIGHT
TOWER (11).