Lochinvar TISUN SCH-I-O - Manual (Page 4)

SCH Collectors Installation & Operation Manual
4
SCH Collector
7 1
7
2
4
8
6
3
5
6. Inlet connection
Copper pipes, .86" diameter.
7. Outlet connection
Copper pipes, .86" diameter.
8. Absorber coils
10 mm copper, serpentine arrangement.
9. Hydraulic connection kit
Connection set with stainless steel corrugated pipe. For connecting
the collector supply and return to the riser. The corrugated pipes
are available in kits with 2 x 6'-7" or 2 x 13'1" length including
sensor well and plug.
10. Sensor well
For measuring the collector outlet temperature directly in
the fluid. The sensor well can be installed on the outlet connection
as shown on the collector label. The sensor must be inserted up to
the end of the sensor well.
11. Plug
This plug is used on the end collector of each array to complete the
water flow path.
How it works...
1. Housing
Powder coated (RAL7016)aluminum frame structure with
PU rigid foam and an aluminum rear wall.
2. Cover
Prismatic solar safety glass, .15" thick, for maximum light
transmission.
3. Insulation
.76" heat resistant, special PU rigid foam and 1.57" mineral
wool with high pressure resistance, emission free, non-
flammable.
4. Absorber
Full surface absorber, laser welded with highly-selective PVD
coating (PVD = Physical Vapor Deposition), serpentine flow.
5. Collector seal
Aluminum profile system with double temperature and UV-
resistant silicone seals, emission free.
1
Introduction
10
9
11