Lochinvar TISUN SCH-I-O - Manual (Page 20)

SCH Collectors Installation & Operation Manual SCH Collectors Installation & Operation Manual
Flange plate shingle (standard)
#SRM20007
The standard flange shingle plate is used for parallel and inclined
installations on asphalt and elastomer roofs.
3
Roof Attachment Installation
4. Choose a cable orientation to ensure proper degree of
angle (see FIG. 3-18).
5. Install the steel cable on the A-frame bracket using the
pin and pin clip provided in the kit (see FIG. 3-19).
6. Attach the steel cable to the joint clamp (fashioned after
the cable orientations in FIG. 3-18.
Figure 3-19 Install Steel Cable on A-frame
INSTALL CABLE
(TURNBUCKLE)
CABLE (TURNBUCKLE)
INSTALLED
INSERT PIN
USE PIN CLIP TO SECURE
THE CABLE
Extend turnbuckle to its fullest extent. NOTICE
7. Before tightening the joint clamp, set the angle of the
cable to greater than or equal to 30°, but less than or
equal to 45° (see FIG. 3-20).
8. Tighten the joint clamp.
9. Use the turnbuckle to tighten the cable.
Figure 3-20 Cable Angle
Figure 3-18 Cable Orientations
• The plates must be screwed into a
support capable bearing the
required load (generally rafters or
concrete).
•
Once installed, the plates must be
sealed to the roof sheet material
(see FIG. 3-24), and only then can the
collector be fitted.
ƽ CAUTION
Figure 3-21 Kit #SRM20007 - Flange Shingle Plate
(Standard) Kit Components
PLATE FLANGE (STD) (1X)
SCREW (M6) (4X)
HEX NUT (M8) (1X)
WASHER (M8) (1X)
HEX BOLT (M8) (1X)
SQUARE DISK (1X)
SCREW (M10) (4X)
Unpacking and checking parts
When unpacking the system, check the model names of the
components of each system and check to be sure you have the
correct number of parts (see FIG. 3-21).
20