Lenovo 1047 - Manual (Page 91)

Table 14. Submenus under the Mass Storage Controller Configuration
Item Option Description
SATA Configuration Disabled / [Enabled] Enable or disable the integrated SATA
controller.
Configure SATA as [IDE] / RAID To select the hard disk drive mode.
If this option is set to IDE, all the
SATA connectors will be configured
as stand-alone SATA connectors.
Notes:
1. The settings in [ ] are the default settings in the Setup Utility program.
2. The SATA Configuration item might not apply because your server came with an integrated SAS controller.
Table 15. Submenus under the SuperIO Configuration
Item Option Description
Serial Port1 Address Disabled; [3F8/IRQ4]; 3E8/IRQ4;
2E8/IRQ3 Select the I/O base address and
interrupt for serial port 1.
Serial Port2 Address Disabled; [2F8/IRQ3]; 3E8/IRQ4;
2E8/IRQ3 Select the I/O base address and
interrupt for serial port 2.
Note: The settings in [ ] are the default settings in the Setup Utility program.
Table 16. Submenus under the USB Configuration
Item Option Description
Legacy USB Support Disabled / [Enabled] / Auto Enable or disable the support on
legacy USB devices.
USB 2.0 Controller Mode FullSpeed / [HiSpeed] Select the USB speed.
Hotplug USB FDD Support Disabled / Enabled / [Auto] Enable or disable the support on the
hot-swap USB diskette drive.
Note: The settings in [ ] are the default settings in the Setup Utility program.
For external USB devices, the USB Mass Storage Device Configuration submenu is as below:
Emulation Type [Auto] / Floppy / Forced FDD / Hard
Disk / CDROM Select the type of the USB device.
Chapter 6 . Configuring the server 79