Life Fitness 880 - Manual (Page 27)

27
FIGURE 28
STEP 29:
FIGURE 29
STEP 28:
• SECURELY assemble the BENCH FOOT (24) to the BENCH FRAME (23) and the ROCKER PIVOT (25) using two 3/8 X 2-3/4”
BOLTS (90), two 3/8” WASHERS (80) and two 3/8” LOCK NUTS (82) as shown in FIGURE 28.
90 3/8 X 2-3/4”
28
80
24
25
82
• Insert four 1/2” FLANGE BEARINGS (54) into the ROCKER PIVOT (25) and the BACK PAD SUPPORT (26) as shown in
FIGURE 29.
28
84
26
54
54
25
1/2 X 4-1/2” 96
• Assemble the BACK PAD SUPPORT (26) to the BENCH SEAT ADJUST (28) using one 1/2 X 4-1/2” BOLT (96) and one 1/2”
LOCK NUT (84). (Note: Tighten this connection enough to remove excess play yet allow the BACK PAD SUPPORT to
rotate freely.)