Linksys VOICE SYSTEM SPA 900 SERIES - Manual (Page 138)

5-33
Linksys IP Phone Administrator Guide
Firmware Version 5.1
Chapter 5 Linksys IP Phone Field Reference
Phone Tab
Supplementary Services
Enable or disable the corresponding supplementary services on the phone. A value of “yes” indicates
enabled; “no” indicates disabled.
Note Some of the parameters in this section do not apply to the WIP310 wireless phone. None of the following
parameters apply to the SPA901.
Field Description
Conference Serv Enable/disable Three way conference service.
Defaults to yes.
Attn Transfer Serv Enable/disable attended-call-transfer service.
Defaults to yes.
Blind Transfer Serv Enable/disable blind-call-transfer service.
Defaults to yes.
DND Serv Enable/disable do-not-disturb service.
Defaults to yes.
Block ANC Serv Enable/disable block-anonymous-call service.
Defaults to yes.
Call Back Serv Enable/disable call-back (a.k.a. repeating dialing) service.
Defaults to yes.
Block CID Serv Enable/disable blocking outbound Caller-ID service.
Defaults to yes.
Secure Call Serv Enable/disable secure-call service.
Defaults to yes.
Cfwd All Serv Enable/disable call-forward-all service.
Defaults to yes.
Cfwd Busy Serv Enable/disable call-forward-on-busy service.
Defaults to yes.
Cfwd On No Ans Serv Enable/disable call-forward-on-no-answer service.
Defaults to yes.
Paging Serv Enable/disable the paging service.
Defaults to yes.
Call Park Serv Enable/disable the call park service.
Defaults to yes.