Linksys VOICE SYSTEM SPA 900 SERIES - Manual (Page 125)

5-20
Linksys IP Phone Administrator Guide
Firmware Version 5.1
Chapter 5 Linksys IP Phone Field Reference
Regional Tab
Distinctive Ring Patterns
Note None of the following parameters apply to the SPA901.
Confirm Tone Brief tone to notify the user that the last input value has been accepted.
Defaults to 600@-16; 1(.25/.25/1).
SIT1 Tone Alternative to the Reorder Tone played when an error occurs as a caller makes an
outbound call. The RSC to trigger this tone is configurable on the SIP screen.
Defaults to 985@-16,1428@-16,1777@-16;20(.380/0/1,.380/0/2,.380/0/3,0/4/0).
SIT2 Tone Alternative to the Reorder Tone played when an error occurs as a caller makes an
outbound call. The RSC to trigger this tone is configurable on the SIP screen.
Defaults to 914@-16,1371@-16,1777@-16;20(.274/0/1,.274/0/2,.380/0/3,0/4/0).
SIT3 Tone Alternative to the Reorder Tone played when an error occurs as a caller makes an
outbound call. The RSC to trigger this tone is configurable on the SIP screen.
Defaults to 914@-16,1371@-16,1777@-16;20(.380/0/1,.380/0/2,.380/0/3,0/4/0)
SIT4 Tone This is an alternative to the Reorder Tone played when an error occurs as a caller makes
an outbound call. The RSC to trigger this tone is configurable on the SIP screen.
Defaults to 985@-16,1371@-16,1777@-16;20(.380/0/1,.274/0/2,.380/0/3,0/4/0).
MWI Dial Tone Played instead of the Dial Tone when there are unheard messages in the caller’s mailbox.
Defaults to 350@-19,440@-19;2(.1/.1/1+2);10(*/0/1+2).
Cfwd Dial Tone Played when all calls are forwarded.
Defaults to 350@-19,440@-19;2(.2/.2/1+2);10(*/0/1+2).
Holding Tone Informs the local caller that the far end has placed the call on hold.
Defaults to 600@-19*(.1/.1/1,.1/.1/1,.1/9.5/1).
Conference Tone Played to all parties when a three-way conference call is in progress.
Defaults to 350@-19;20(.1/.1/1,.1/9.7/1).
Secure Call Indication Tone Played when a call has been successfully switched to secure mode. It should be played
only for a short while (less than 30 seconds) and at a reduced level (less than -19 dBm) so
it does not interfere with the conversation.
Defaults to 397@-19,507@-19;15(0/2/0,.2/.1/1,.1/2.1/2).
Page Tone Specifies the tone transmitted when the paging feature is enabled.
Defaults to 600@-16;.3(.05/0.05/1).
Alert Tone Played when an alert occurs.
Defaults to 600@-19;.2(.05/0.05/1).
Field Description