Removing the simple-swap backplate – Lenovo 6528 User Manual
Page 94
5. Connect the hard disk drive fan assembly cable to the system board (see
“System-board internal connectors” on page 19 for the location of the hard disk
drive fan connector).
6. Reinstall the hard disk drives.
Note: Before you continue, check all internal power cables to be sure that
they are connected to the system board and other optional devices.
7. Install the lower bezel (see “Installing the lower bezel” on page 36).
8. Install the side cover (see “Installing the side cover” on page 33).
9. Lock the side cover if you unlocked it during removal.
10. Reconnect the external cables and power cords; then, turn on the attached
devices and turn on the server.
Removing the simple-swap backplate
This procedure applies only to server models with the simple-swap SATA backplate
installed on the back of the hard disk drive cage.
To remove the simple-swap backplate, complete the following steps:
Note: You need a screwdriver in order to complete the steps.
1. Read the safety information that begins on page vii and “Installation guidelines”
2. Turn off the server and all attached devices; then, disconnect all power cords
and external cables.
3. Unlock and remove the side cover (see “Removing the side cover” on page
4. Remove the lower bezel (see “Removing the two-piece bezel” on page 34).
5. Remove the simple-swap hard disk drives that are installed in the hard disk
drive cage (see “Removing a simple-swap hard disk drive” on page 53).
6. Remove the hard disk drive fan assembly from the hard disk drive cage (see
“Removing the hard disk drive fan assembly” on page 75).
7. Disconnect the power cable from the simple-swap backplate.
8. Disconnect the signal cable from the system board.
9. Press and hold the drive cage release tab; then, rotate the drive cage out of
the chassis until the retaining tab on top of the cage locks into place.
10. Lift up on the retaining latch at the top of the drive cage; then, tilt the top of the
simple-swap backplate away from the drive cage until it is clear of the locating
pins.
78
ThinkServer TS200 Types 6522, 6523, 6524, 6525, 6526, 6528, 6529, and 6530: Installation and User Guide