LG WM3001H*A - Manual (Page 11)

I N S TA L L AT I O N I N S T RU C T I O N S
When removing the washer from the carton base, be
sure to remove the foam tub support in the middle of the
carton base.
If you must lay the washer down to remove the base
packaging materials, always lay it carefully on its side. Do
NOT lay the washer on its front or back.
IMPORTANT: To prevent internal damage during transport,
the washer is equipped with 4 shipping bolts and plastic
retainers. These bolts and retainers MUST be removed
before operating the washer.
• Failure to remove shipping bolts and retainers may cause
severe vibration and noise, which can lead to permanent
damage to the washer. The cord is secured to the back of
the washer with a shipping bolt to help prevent operation
with shipping bolts in place.
Remove the retainers by turning them slightly
while pulling. Rotate and press the hole caps
into the shipping bolt holes.
Starting with the bottom 2 shipping bolts,
use the included wrench to remove the
4 shipping bolts by turning them
counterclockwise.
1
Shipping
Bolts
2
NOTE: Save the bolts and retainers for
future use. To prevent damage to internal
components, the shipping bolts and
retainers must be installed when
transporting the washer.
Retainer
Hole Cap
Carton Base Foam Tub
Support
UNPACkINg AND REmOVINg SHIPPINg BOLTS
11